6
4.7 Under deck fitting
Lightly grease all moving parts.
1. Ensure drive key is in place then gently slide the motor/
gearbox up the drive shaft until it contacts the deck.
NOTE: Position the motor/gearbox away from the rope/
chain pipe fall.
2. Check the motor/gearbox and windlass mounting
surfaces are parallel.
3. Assemble the washer then the M8 nut, secure with
Loctite® threadlock to 21Nm torque.
NOTE: If using silicone or other rubbery type sealant, it
is advisable to allow curing of the sealant before final
tightening of the mounting nuts
M8
Washer
M8 Nut
4.8 Loading rope/chain
For safety and performance Lewmar recommends the use of matched Lewmar anchor rodes.
1
2
3
4
5
⚠ WARNING! Isolate (turn off) the windlass
using circuit breaker / isolator.
1. Remove cover.
2. Pull out control arm.
3. Feed anchor rope/chain into
entry hole. Tie off to suitable
strong point.
1. Replace cover. Release control arm
and wrap rope/chain around gypsy.
2. Power load rest of anchor rope/chain.
DO NOT use a permanent
adhesive/sealant eg.5200
GB
