11
CA R E & M A I N T E N A N C E
Check Filter Indicator
Cleaning the Filters
Cleaning the Air Purifier
A.
The Fine Preliminary Filter should be
cleaned once a month to increase
efficiency and extend the life of your
filter. Clean the Fine Preliminary Filter
using a brush or vacuum hose to
remove hair, dust, and large particles.
Replacing the Filters
1.
Unplug the air purifier, then remove the
filter cover (see Getting Started, page 7).
2.
Remove the old filters.
The Check Filter Indicator will light up as
a reminder to check the filters. Depending
on how often you use the air purifier, the
indicator should turn on at about 6–8 months.
You may not need to change your filters
yet, but you should check them when the
indicator light turns on.
When your air purifier is set up with the
VeSync app, you can also check the app to
see your remaining filter life. You will also
receive a notification from VeSync when it’s
time to check your filter.
The VeSync app uses a scientific algorithm to
determine your filter life based on air quality,
amount of use, and other factors. This will
provide a more accurate estimate than the
Check Filter Indicator. The VeSync filter life
percentage is based on 12 hours of daily use.
Reset the Check Filter Indicator by pressing
the black Filter Indicator Reset Button in the
vent on the side of the air purifier
(see page 13).
Note:
Make sure you’re cleaning the
correct side of the Combination Filter.
Only
clean the side of the filter covered
with the Fine Preliminary Filter.
A
B
C
•
Unplug before cleaning.
•
Wipe the outside of the air purifier with
a soft, dry cloth. If necessary, wipe
the housing with a damp cloth, then
immediately dry.
•
Vacuum the inside of the air purifier.
•
Do not
clean with water or any other
liquid, to avoid risk of electric shock.
•
Do not
clean with abrasive chemicals or
flammable cleaning agents.
3.
Clean out any remaining dust or hair
inside the air purifier using a vacuum
hose. Do not use water or liquids to
clean the air purifier.
4.
Unwrap the new filters. Place the High-
Efficiency Activated Carbon Filter inside
the housing. Make sure the pull tabs are
facing out.
5.
Install the Fine Preliminary/True HEPA
Combination Filter into the housing.
Make sure the pull tabs are facing out.
6.
Replace the filter cover. The air purifier
will not turn on unless the filter cover is
replaced correctly.
7.
Reset the Check Filter Indicator
(see page 13).
B.
Do not
clean the True HEPA Filter. Fine
dust may be released back into the air
if cleaning is attempted. Only clean the
Fine Preliminary Filter.
C.
The High-Efficiency Activated Carbon
Filter does not require cleaning.
