P6
MOUNT FIXTURE
CAUTION:
LEO™ LED Zoom Ellipsoidal may be mounted in any position (max. t45° to -90° from horizontal);
however, make sure there is adequate room for ventilation, configuration, and maintenance.
The fixture comes with a hanging/mounting yoke to which you can attach mounting clamps. The bracket
has a 0.5" (12mm) hole, which is appropriate for this purpose. Make sure the clamps are capable of
supporting the weight of this product.
FIXTURE ANGLE ADJUSTMENT
The fixture can be tilted up and down to position the light where it is needed.
Step 1: Loosen the yoke fastening knob, use the handle on the rear of the unit to keep the fixture
steady.
Step 2: With the fixture turned on, use the handle to tilt it to the desired angle.
Step 3: Tighten the yoke fastening knob.
CONNECT DMX
LEO™ LED Zoom Ellipsoidal uses 5-pin XLR connectors for signal transmission and can be controlled
via DMX-512 protocol. The diagram below shows the fixture’s XLR-5 signal ports.
Step 1: Connect the (male) 5-pin connector side of the DMX cable to the output (female) 5-pin connector
of the DMX console.
Step 2: Connect the end of the cable coming from the console which will have a (female) 5-pin connector
to the fixture’s input port ("DMX IN") consisting of a (male) 5-pin connector.
Step 3: Then, proceed to connect from the output port ("LOOP") as stated above to the input of the
following fixture and so on.
Always mount this product in a safe position with adequate ventilation and away from
a heat source, at least 20" (50 cm) from adjacent surface, and no flammable materials
close by while it is operating, at least 8" (20 cm) from adjacent surfaces.
Always connect the provided Safety Cable to the fixture and a suitable anchor. The safety
cable should loop through the fixture yoke and be connected to a secure attachment at
the other end.
XLR Pin # Signal
1
common
2
data -
3
data +
4
NC
5
NC
1
2
3
4
5
5
4
3
2
1
DMX IN
LOOP
XLR-5 signal ports