Leviton evr-green EV320, Installation Manual, Page: 12 / 18

Operating Steps
1. Standby - Blue Light
After power-on, blue(READY), green(CHARGE) and red light
(FAULT) all lit. Enter standby mode and the blue light (READY)
is steady on.The time from power on to
the green light on is 1.5 minutes.
2. Plug in Connector
Please plug the charging connector into the vehicle charging
inlet. when you tap the RFID card first, it needs to complete the
insertion of the charging connector within 2 minutes, otherwise
you need to tap the RFID card again.
3. Charging
The green light (CHARGE) turns to flash automatically,
charging is in process.
NOTE:
• If the red light (FAULT) is lit, plug-in the vehicle connector
again.
• If red light is still lit, please refer to “Error and
Warning Messages.”
4. Charging Finished
When charging is finished, the green light (CHARGE)
is constantly lit, press the button on connector to stop charging.
8 OPERATING INSTRUCTIONS
12
8.1 Operating Procedures
• User authorization
• Connect to Vehicle Charging Inlet
• Charging Message
• Charging completed
NOTE: Device may need to be activated or de-activate with RFID cards. EV320 will be shipped with
RFID inactive. EV32W, EV480, EV48W and EV48S will be shipped standard with RFID active.
READY
CHARGE
NOTE: RFID access control is disabled by default on all units. See section 8.3 for
operation with RFID enabled
WEB
VERSION