LEVITAS PIUMA UP Series, Instruction Manual

Page: 35 / 72

11
ENGLISH
NOTE: 1. Ensure that the compressor unit is suitable for the local voltage. Do not position
the device in a manner that makes it difficult to use the circuit breaker.
2. The plug is also used to disconnect the device.
WARNING: The pump provided with the mattress can only be used for
mattresses recommended by the manufacturer. Do not use it for any other
purpose. (part applied: air mattress)
5. Switch on
NOTE: The unit can be disconnected to switch off the device.
NOTE: (For models WITHOUT the low air leak function) during power failures, the quick
connector can be covered with the transport cap to maintain the air pressure inside the cells.
NOTE: After installation, ensure that the cable or any excess tubes are removed from the
transit area, to avoid tripping. Position all DEVICES in a manner to ensure doctors and carers
have easy access to the patient.
10.2. Only for the digital compressor model
Based on the patient’s weight, set the required pressure using the weight settings (40~200 kg).
NOTE:When the headboard is raised, the weight setting must be increased by at least one
step.
Cycle time
There are four cycle times to choose from: 10 minutes, 15 minutes, 20 minutes, 25 minutes.
Press the button to select.
The pump starts up, always in Auto Firm mode. No other functions on the panel can be used
during initial inflation. When the mattress is completely inflated, the pump automatically passes
into alternate mode.
Press the Mode button to change the mode. The sequence is: Static, Seat I Alternate,
Seat i Static, Max Firm, Alternate.
11. BEFORE EVERY USE
Check correct assembly of the device, particularly connection of the tubes between the
mattress and the compressor.
12. WARNINGS ON USE
DANGER - To reduce the risk of electrocution
1. Disconnect the device after every use
2. Do not use the device while washing the patient
3. Do not position the device in a place from which it could fall
4. Do not position the device near or allow it to fall into water or any other liquid
5. Add disconnect immediately at the end