9
Attaching Rubber Feet
A. Make sure mounting surface on the bottom of the Switch is
grease and dust free.
B. Remove adhesive backing from your Rubber Feet.
C. Apply the Rubber Feet to each corner on the bottom of the
Switch. These footpads can prevent the Switch from
shock/vibration.
Figure 2-4. Attaching Rubber Feet to each corner on the bottom of the Switch
Rack-mounted Installation
The
24TX Auto MDIX
comes with a rack-mounted kit (Not a standard
option for this switch) and can be mounted in an EIA standard size,
19-inch Rack. The Switch can be placed in a wiring closet with other
equipment.
Perform the following steps to rack mount the switch:
A. Position one bracket to align with the holes on one side of the
switch and secure it with the smaller bracket screws. Then attach
the remaining bracket to the other side of the Switch.
B. After attached both mounting brackets, position the 24
Port 10/100
Auto MDIX
in the rack by lining up the holes in the brackets with
the appropriate holes on the rack. Secure the Switch to the rack
with a screwdriver and the rack-mounting screws.
Figure 2-5. Attach
mounting brackets
with screws
