FNC-0107TX 10/100Mbps Fast Ethernet Adapter
7
A flashing
green
LED indicates that the
adapter is sending or receiving data.
INSTALLATION
Installation of a FNC-0107TX 10/100Mbps Fast
Ethernet Adapter requires Hardware installation
first, then BIOS and Software installation.
Hardware Installation
1.
Trun OFF the computer, unplug its power
cord and open the computer case.
2.
Insert the contact edge of the FCN-0107TX
10/100Mbps Fast Ethernet Adapter into the
connector of any available PCI Bus Master
e xpansion slot. Press the card firmly into
the connector and ascertain that the card
contacts are fully seated in t he connector.
3.
For WOL model, connect the WOL cable to
the NIC WOL connector. Both ends of the
WOL cable are identical, so either and may
be used.
4.
Install the bracket screw, which secures the
card to the cinouter chassis.
5.
Replace the computer’s case and connect
the network cable to newly installed
network card. Reconnect the computer’s
power cord and plug it into the power
outlet.