Level GB 060 515 C, User Manual

Page: 17 / 24

17
ED 060 250 - Microphone
Install to the side pole of windshield close to driver’s head. Do not install close to the
GSM antenna – to prevent interferences. After installation, set the microphone
sensitivity as described in table of SMS commands.
ED 060 260 - Loudspeaker with amplifier
Install near the car alarm unit. Set the volume to prevent acoustic coupling, the
procedure is described in table of SMS commands. Set the sensitivity so the
amplifier turns on only during phone call – not spontaneously.
CB 160 021 - RS 232 cable
Take out to a suitable place in vehicle cabin, preferably near the front passenger
seat. To connect a PDA, cable reduction CB 160 017 will be needed.
The unit is switched on by connecting external power supply. When the external
power supply is disconnected, the unit will be powered from internal backup battery.
During transport and storage, turn on the internal battery power supply by pressing
the INIT button on car alarm unit.
3.4. Checking Functionality
Start the car alarm unit as described in chapter “Quick start”.
Checking external and internal power supply
SMS Inquiry
Reply 1 – external power
Value x
Value y
pin_POWER
Power_x_Bat_y
x = ExtPwr - external power
x = Bat – power from internal backup battery
Internal battery voltage
Checking GSM signal
SMS Inquiry
Reply
Value x
Value y
Value z
Value q pin_GSM
GSM_x_Credit_y_CellId_z_Signal_q
Name of GSM network
Balance of prepaid credit on SIM card
Name of GSM cell (BTS)
Signal strength (0 – 32, 32 = maximum)
Note: GSM signal lower than 5 is not usable, it will be necessary to move the GSM
antenna to a better placement. GSM signal can be checked also from signal LEDs
on the car alarm unit.
Checking GPS
Send SMS message to the phone number of SIM card placed in the car alarm unit.
After installation or INIT of unit, it is recommended to take the vehicle to a place with
good view of sky, turn on the ignition and wait about 5 minutes to get valid GPS
data.