Leuze electronic DB 112 B, Technical Description

Page: 11 / 17

Commissioning
Leuze electronic DB 112 B 9
TNT
35/7-2
4
V
7 Commissioning
Notice!
If the indicators flash during the initial commissioning, a calibration must first be performed
on a single sheet.
First apply operating voltage. An alignment mode is available for commissioning. This can
be used to check the alignment of the transmitter and receiver.
Alignment mode
Notice!
After exiting alignment mode, it is absolutely necessary to perform a calibration .
Press the TEACH IN button
for > 5s and < 10s
LEDs and flash synchronously at 3Hz

LED green :
Alignment
OK Exit:
press the
TEACH IN button < 5s

LED yellow :
Alignment
critical
Align transmitter and receiver until
LED
is green.
Only then is it possible to exit align-
ment mode!
Extraordinary exiting of alignment
mode is possible only by means of
Power OFF!

LED red :
Alignment
bad
Align transmitter and receiver until
LED
is green.
Only then is it possible to exit align-
ment mode!
Extraordinary exiting of alignment
mode is possible only by means of
Power OFF!
