Fast commissioning / operating principle
Leuze electronic
AMS 384
i
10
TNT
35/7-2
4
V
3.2
Connecting the voltage supply
The laser measurement system is connected using M 12 connectors. The voltage supply is
connected via the
PWR
M 12 connection.
Detailed information can be found in chapter 7.
3.3
Display
Once the laser measurement system is supplied with voltage, the device status as well as
the measured position values can be read on the display. The display automatically switches
to the display of the measurement values.
Use the up/down buttons
to the left of the display to read and change a wide range
of data and parameters.
Depending on connected interface, the network address or IP addresses must be configured
via the display.
Detailed information can be found in chapter 8.
3.4
AMS 384
i
on the Interbus
The laser measurement system is delivered with preset Interbus parameters. The AMS 384
i
is classified with Ident code 32
H
, which is stored in the control. The AMS 384
i
is connected
via the BUS IN M 12 connection or, in the case of a continuing network, via BUS OUT.
Detailed information can be found in chapter 9.
