6
Assembly
Before assembling, please check whether the parts are in good condition and make sure that the parts
are not damaged or missing. Then put all the components in a clean, spacious area, and remove the
packaging materials. Do not discard the packaging materials until all assembly steps are completed.
1. Install the front stabilizer bar (2) and the rear stabilizer bar (3) on the main frame with four
screws (14), four flat washers (17), and four locknuts (16) using the open-end wrench
(20).
Notes
：
● While assembling the front stabilizer bar, the transport wheels on the stabilizer bar are in
the front.
● If the equipment is placed on an uneven surface, adjusting the leveling feet (25) on the
front/rear stabilizer bar can help, but may not compensate for extremely uneven surfaces.
(1)
(2)
(16)
(14)
(25)
(17)
(3)
(20) Open-end Wrench
(17) Flat Washer
Φ8×Φ19×2T
(16) Locknut
M8
(14) Screw
M8×40L×S20L
15
13
