11
2. System Installation
(2-3-2) On RF pairing interface, select by pressing on
or
until flashing
show up on screen’s left side, press
to send thermostat’s pairing command
to gateway; pairing success if
flashing on screen’s right side, pairing failed if E01 or
E02 is flashing on screen’s right side, in this case, you need to send the pairing command
with receiver by pressing
once again until pairing success.
(2-4) Gateway is still under pairing mode even one thermostat’s pairing succeed, if you
have more thermostats need to be paired, you may continue to pair them with gateway
manually. (1 gateway could RF communicate with 10 thermostats at one time).
(2-5) Exit pairing mode by hold-pressing
until the LED recover ro its status before
pairing.
(2-6) Once thermostat and gateway were paired successfully, their RF communication
started normally,
will show up on the top right corner of thermostat’s screen.
