- 6 -
Curtain and soft furnishing care
• Creases and wrinkles can be removed from
draperies by hanging them over a pole.
• Then simply follow the directions given under
“Clothing care”.
• Always carry out a test first at a concealed part.
• If you are using the appliance horizontally, every
now and then hold it upright so as to have the
maximum steam performance.
Fluff brush
• Threads, fluff and hairs can be easily removed
with the red fluff brush
e
by slowly brushing
over the garment with it from left to right.
• You can clean the fluff brush
e
by brushing with
it in the opposite direction (from right to left)
over, for example, a remnant of material.
Ironing function
• Dismantle the brush attachment
w
from the
appliance (see “Attaching/detaching the brush
attachment”).
• Connect the appliance to a correctly installed
and earthed mains power socket.
• Adjust the temperature regulator
3
as per the
international point symbols (Care Label) or the
type of material. The heating-up control lamp
5
glows. As soon as the set temperature has been re-
ached, the heating-up control lamp
5
goes out .
Washing label Type of material Temperature
regulator
3
Chemical fibres,
e.g. viscose,
polyester
•
(low
temperature)
Silk, Wool
••
(medium
temperature)
Cotton, Linen
•••
(high
temperature)
Note:
If doubt exists, start with a low temperature and
gradually increase it to a higher one. With sensitive
materials we recommend carrying out an ironing
test at a concealed part (inside seam).
• Should the heating-up control lamp
5
glow during
the process, release the steam blast button
8
and wait for a few moments until the heating-up
control lamp
5
extinguishes.
• You can repeatedly press the steam blast button
8
until the heating-up control lamp
5
glows or
water drips from the sole of the iron
0
. Then,
wait until the heating-up control lamp
5
extin-
guishes before activating a further blast of
steam.
Note:
Should you press the steam blast button
8
whilst
the heating-up control lamp
5
is glowing the result
will be condensed water instead of steam, and water
will drip from the sole of the iron
0
.
Should the water tank
1
become empty while the
appliance is in use, remove the plug
7
from the
power socket before refilling it.
• If you want to put the appliance down during
use, fold out the stands
9
to the front and place
the appliance on them. When you are ready to reu-
se the appliance, simply fold the stands
9
back
to the rear.
After using the steam brush
• Place the temperature regulator
3
at the position
"MIN".
• After use, ALWAYS remove the plug
7
from the
power socket.
• Pour away any water remaining in the water
tank
1
to do this, open, the water fill opening
2
of the water tank
1
, turn the appliance upsi-
de down and lightly swivel it.
IB_KH1270_E40979_LB4 17.10.2008 11:05 Uhr Seite 6
