5
6
4.3 Mounting the PAS Sensor
The PAS sensor is mounted on the saddle tube or down tube and is secured by cable tie. Please
remove the red foil from the back of the PAS sensor to fix it to the seat tube or down tube. The
distance between PAS sensor and PAS disc should be approx. 5 mm. Working surface is
stamped on one side of the PAS disc, this side must point towards the sensor!
CAUTION
The PAS sensor must be at the level of the magnets of the PAS disc and run vertically through
the centre of the bottom bracket.
4. PAS Sensor & PAS Disc Installation
PS-DH-SSP
PD-DH2
4.1 Mounting options PAS Sensor & PAS Disc:
PAS sensor & PAS disc are for mounting only.
On the left side of the bottom bracket.
The installation is not suitable for the Hollowtec 2 and Octalink bottom brackets shown.
A PAS sensor and a PAS disc are required for the right side.
If one of these bottom brackets is fitted to your bike, please contact customer service
4.2 Mounting PAS Disc
The PAS disc is mounted on the left side of the bottom bracket, the fixation takes place by means
of the metal ring.
Down Tube
Seat Tube
Fine tune the distance
between PAS sensor
and PAS disc.
The head of PAS sensor
should aim at the round
hole around the PAS disc.
Fix with
CableTie
-
FRONT VIEW
-
Connect with the
connector on controller
or
-
SIDE VIEW
-
