Safety instructions
General safety and application notes for Lenze MOBILE devices
Ò
11
EDSMDAG EN 2.0
ƒ
The devices and related components can − depending on the degree of protection −
have live, movable or rotating parts during operation.
– Surfaces can be hot.
– Do not remove required covers.
– Do not touch exposed contacts or non−insulated cable ends.
– For more information, please see the documentation.
ƒ
Before touching conductive components, ensure isolation from supply by means of
measurement.
The device−specific safety and application notes given in the chapter "Residual hazards"
of this documentation must be observed.
Application as directed
The devices meet the requirements of the Low−Voltage Directive 2006/95/EC. The
harmonised standard EN 61800−5−1 applies to the devices.
The devices marked with E1 are components which are designed for installation in vehicles
(ECE approval). They are not to be used as domestic appliances, but only for industrial
purposes according to EN 61000−3−2.
The technical data and supply conditions can be obtained from the nameplate and the
documentation. They must be strictly observed.
Commissioning (i.e. start of the operation as intended) of devices installed in vehicles is
only permissible if the following has been verified:
ƒ
The vehicle corresponds to the valid vehicle standards (e.g. ECE R100, safety
requirements with respect to the electric power train of road vehicles); EN 60204 is
observed.
ƒ
The EMC Directive 2004/104/EC (last supplemented by 2009/19/EC) is complied
with.
Transport, storage
Please observe the notes on transport, storage, and appropriate handling.
Observe the climatic conditions according to the technical data.
Installation
You have to mount, connect and cool the devices according to the specifications of the
respective documentation. The equipotential bonding has to be dimensioned sufficiently
and protected against corrosion.
When plug connections are open, the degree of pollution 2 must not be exceeded
according to EN 61800−5−1.
Ensure proper handling and avoid excessive mechanical stress.
Do not touch any electronic components and contacts. The devices contain electrostatic
sensitive devices that can be damaged easily by improper handling. Damaged devices
must not be commissioned.
