Lenze ECSDE012, Operating Instructions Manual

Page: 74 / 169

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Description of the function keys
7
74
EDBCSXE040 EN 6.0
Number
Active level Meaning Explanation
Menu level Menu number
l
Display is only active when operating
Lenze devices of the 8200 vector or
8200 motec series.
l
No menu for ECSxE power supply
module
Code level Four−digit code number
Number
Active level Meaning Explanation
Menu level Submenu number l Display is only active when operating
Lenze devices of the 8200 vector or
8200 motec series.
l
No menu for ECSxE power supply
module
Code level Two−digit subcode number
Parameter value
Parameter value with unit
Cursor
The figure over the cursor can be changed directly in the parameter level.
!
Function keys
For description see the following table.
7.3.3 Description of the function keys
Note!
Key combinations with :
Press and keep it pressed, then press second key in addition.
Key Function
Menu level
1)
Code level Parameter level Operating level
Change to parameter
level Change to operating
level
Change to code level
Load predefined
configurations in the
menu "Short setup"
2)
Accept parameters
when SHPRG
or
SHPRG is displayed
"
#
Change between menu
items
Change code number
Change figure over
cursor
"
#
Quick change between
menu items Quick change of code
number Quick change of figure
over cursor
$
Change between main menu, submenus and
code level
Cursor to the right
%
Cursor to the left
&
Cancel function of
'
key, the LED in the key goes out.
'
Inhibit the controller, LED in the key lights up.
Reset fault (TRIP reset): 1. Remove cause of malfunction
2. Press
'
3. Press
&
1)
No menu for ECSxE power supply module
2)
Only active when operating Lenze devices of the 8200 vector or 8200 motec series.