REPAIR AND MAINTENANCE:
Belt and rear wheel replacement
Tools required: 4mm hex wrench, 5mm hex wrench, two 13mm wrenches, 10mm wrench,
Phillips
screwdriver
1. Using a 4mm hex wrench remove the 4 bolts from the rear axle cover on both sides of the scooter.
2
.
Loosen brake cable pinch nut with
10mm
wrench.
3
.
Remove the brake arm bolt with a Phillips screwdriver and 8mm wrench. Using two
13mm
wrenches loosen the rear wheel axle nuts and adjustment washers and slide the belt off of the rear
wheel pulley. Pull the wheel towards the rear of the frame.
4. Note the location of all rear wheel hardware and ensure to properly reinstall all items.
5. If replacing the belt remove the motor bolts with a 5mm hex wrench. Slide motor out of the frame
slightly so that there is enough room to remove/replace the belt onto the motor gear. Replace spacers
and retighten bolts.
6. Install replacement wheel into the frame and slide belt back onto the pulley. Do not tighten axle nuts
yet. Install brake arm hardware, do not tighten yet.
Summary of Contents for ES70BL
Page 17: ...SCOOTER COMPONENTS ...