Lenovo ThinkSystem SR860, Maintenance Manual

Page: 126 / 212

3) If there is any old thermal grease on the processor, gently clean the top of the processor using
an alcohol cleaning pad.
Note: If you are applying the new thermal grease on the top of the processor, make sure to do it
after the alcohol has fully evaporated.
3. If you are replacing a processor:
a. Remove the processor identification label from the heat sink and replace it with the new label that
comes with the replacement processor.
b. Apply the new thermal grease (1/2-syringe, 0.65 g) to the top of the new processor. If you have
cleaned the top of the processor with an alcohol cleaning pad, make sure to apply the new thermal
grease after the alcohol has fully evaporated.
Attention: You should use blue thermal grease (part number 01KP765) when replacing the
processor if that grease is available in your country. If it is not available, use gray thermal grease (part
number 41Y9292).
Figure 112. Thermal grease application
1) Carefully place the processor and retainer on a flat surface with the processor-contact side
down.
2) Apply half a syringe of thermal grease, approximately 0.65 g, to the center of the processor top.
4. If you are replacing a heat sink, remove the processor identification label from the old heat sink and
place it on the new heat sink in the same location. The label is on the side of the heat sink closet to the
triangular alignment mark.
If you are unable to remove the label and place it on the new heat sink, or if the label is damaged during
transfer, write the processor serial number from the processor identification label on the new heat sink in
the same location as the label would be placed using a permanent marker.
5. Assemble the processor and heat sink, if these components are separate.
Notes:
• If you are replacing a processor, install the heat sink onto the processor and retainer while the
processor and retainer are in the shipping tray.
• If you are replacing a heat sink, remove the heat sink from its shipping tray and place the processor
and retainer in the opposite half of the heat sink shipping tray with the processor-contact side down.
To prevent the processor from falling out of the retainer, hold the processor-retainer assembly by its
sides with the processor-contact side up until you turn it over to fit in the shipping tray.
118
ThinkSystem SR860 Maintenance Manual