Lenovo ThinkSTaTion series, Hardware Maintenance Manual, Page: 114 / 304

6. Remove the speaker and speaker cable from the computer.
7. Route the new speaker cable and then position the new internal speaker tabs 3 into the metal speaker
slots and then push the internal speaker downward until the speaker locking tabs snap into position.
8. Connect the speaker cable to the system board. See “Locating parts on the system board ” on page 79.
9. Go to “Completing the FRU replacement” on page 106.
Completing the FRU replacement
After replacing FRUs, you need to install any removed parts, replace the cover, and reconnect any cables,
including telephone lines and power cords. Also, depending on the FRU that is replaced, you might need to
confirm the updated information in the Setup Utility program.
Note: When the power cord is first plugged in, the computer might appear to turn on for a few seconds and
then turn off. This is a normal sequence to enable the computer to initialize.
1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left
inside your computer.
2. Replace the cover.
3. Reconnect the external cables and power cords to the computer. See “Rear connectors” on page 107.
4. If you have replaced the system board, you must update (flash) the BIOS. See “Flash update
procedures” on page 285.
5. Some FRU replacements require the configuration to be updated. See Chapter 6 “Using the Setup
Utility” on page 39.
106
ThinkStation Hardware Maintenance Manual