Lenovo THINKSTATION 7782, Hardware Maintenance Manual

Page: 83 / 184

7. Pivot the card latch to the closed position to secure the PCI card.
Figure 10. Installing a PCI card
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 102.
Installing or replacing a memory module
Attention: Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the ThinkStation User Guide . To obtain a copy of the ThinkStation User Guide, go to:
http://www.lenovo.com/ThinkStationUserGuides.
This section provides instructions on how to install or replace a memory module.
Your computer has four slots for installing or replacing DDR3 UDIMMs that provide up to a maximum of 16
GB system memory. When installing or replacing a memory module, use the following guidelines:
• Use 1 GB, 2 GB, or 4 GB DDR3 UDIMMs in any combination up to a maximum of 16 GB.
• Install memory modules in the sequence of DIMM 2, DIMM 4, DIMM 1, and DIMM 3. See “Locating
parts on the system board” on page 71.
To install or replace a memory module, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See “Removing the computer cover” on page 72.
3. Lay the computer on its side for easier access to the system board.
Chapter 9
.
Replacing FRUs
77