Lenovo ThinkCentre M90p, Maintenance Manual, Page: 57 / 112

Diagnostic Error Code FRU/Action
014-015-XXX Parallel port External Loopback failure
1. Wrap plug
2. System board
014-027-XXX Parallel port Configuration/Setup error 1. Run Setup, enable port
2. Flash the system. See “Updating (flashing) BIOS
from a disc” on page 98
3. System board
014-03X-XXX 014-04X-XXX Parallel port failure
System board
014-195-XXX Parallel port Test aborted by user Information only Re-start the test, if necessary
014-196-XXX Parallel port test halt, error threshold
exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
014-197-XXX Parallel port test warning 1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 “Using the
Setup Utility program” on page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
014-198-XXX Parallel port test aborted 1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test. See “Updating
(flashing) BIOS from a disc” on page 98
3. Go to “Undetermined problems” on page 64
014-199-XXX Parallel port test failed, cause unknown
1. Go to “Undetermined problems” on page 64
2. Flash the system and re-test. See “Updating
(flashing) BIOS from a disc” on page 98
3. Replace component under function test
014-2XX-XXX 014-3XX-XXX Parallel port failure 1. External parallel device
2. System board
015-000-XXX USB port Interface Test Passed
No action
015-001-XXX USB port Presence 1. Remove USB device(s) and re-test
2. System board
015-002-XXX USB port Timeout 1. Remove USB device(s) and re-test
2. System board
015-015-XXX USB port External Loopback failure 1. Remove USB device(s) and re-test
2. System board
015-027-XXX USB port Configuration/Setup error 1. Flash the system. See “Updating (flashing) BIOS
from a disc” on page 98
2. System board
015-032-XXX USB port Device Controller failure System board
Chapter 7
.
Symptom-to-FRU index
51