Lenovo 7Y54, Maintenance Manual

Page: 53 / 138

Figure 34. Simple-swap disk drive installation
Step 1. Slide the drive into the drive bay. Make sure the drive handle is in the open position.
Step 2. Lock the drive into place by rotating the drive handle inward until it clicks.
After you install all simple-swap disk drives, complete the following steps:
1. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
2. Reconnect power cords and all external cables.
Drive backplate replacement
Use the following information to remove and install the simple-swap drive backplate.
Remove the simple-swap drive backplate
Use this information to remove the simple-swap drive backplate.
Before you remove the simple-swap drive backplane, complete the following steps:
1. Read “Safety” on page iii and “Installation Guidelines” on page 31 to ensure that you work safely.
2. Turn off the server. Disconnect the power cords and all external cables (see “Power off the server” on
page 10 ).
3. If server is installed in a rack, remove the server from the rack.
4. Remove the top cover (see
“Remove the top cover” on page 86 ).
5. Disconnect the cables from the system board and the RAID card (if installed).
6. Pull all the drives and fillers slightly out to disengage them from the backplate.
To remove the simple-swap drive backplate, complete the following steps:
Notes:
There are three types of backplate supported by the server, all are removed and installed in a similar
method.
• Two 3.5-inch drive backplate
• Four 3.5-inch drive backplate (connects to onboard connectors)
• Four 3.5-inch drive backplate (connects to RAID adapter)
Chapter 3
.
Hardware replacement procedures
45