Chapter 6. Installing hard disk drives and configuring RAID
This chapter contains information about installing hard disk drives and configuring Redundant Array of
Independent Disks (RAID) for this product.
Note:
The information about configuring RAID in this chapter only applies for a Windows environment. For
information about configuring RAID in a Linux environment, contact your Linux software provider.
Installing SATA or SAS hard disk drives and configuring RAID
This section contains information about the required number of SATA or SAS hard disk drives for the
supported level of RAID configuration.
Note:
You can install a combination of SATA and SAS hard disk drives within the same computer. However,
SATA and SAS hard disk drives cannot be installed within the same RAID array.
Installing SATA or SAS hard disk drives
Your computer must have the minimum number of SATA or SAS hard disk drives installed for the supported
level of RAID below:
• RAID Level 0 – Striped disk array
– Two hard disk drives minimum
– Better performance without fault tolerance
• RAID Level 1 – Mirrored disk array
– Two hard disk drives minimum
– Improved read performance and 100% redundancy
• RAID Level 5 – Block-level striped disk array with distributed parity
– Three hard disk drives minimum
– Data striped at the byte level
– Stripe error correction information
– Better performance and fault tolerance
• RAID Level 10 – Combining features of RAID 0 and RAID 1
– Four hard disk drives minimum
– Very high reliability combined with high performance
– Fault tolerance
To install a new SATA or SAS hard disk drive, refer to the installation procedure in “Replacing a hard disk
drive” in the
ThinkStation Hardware Installation and Replacement Guide
.
Entering the Marvell BIOS Setup to configure SATA or SAS RAID
This section describes how to enter the Marvell BIOS Setup to configure a SATA or SAS RAID.
1. Turn on the computer after you have installed the required number of SATA or SAS hard disk drives.
2. Press Ctrl+M when prompted to enter the Marvell BIOS Setup to configure SATA/SAS RAID.
© Copyright Lenovo 2009, 2011
21
Summary of Contents for 415539U - Ts D20 Twr X/2.26 4Gb 500Gb Dvdr Wvb64
