Lenovo 3569, Maintenance Manual

Page: 89 / 128

Replacing the optical drive
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety
information” in the
Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the
Safety, Warranty, and Setup Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the optical drive.
Note: The optical drive is available only in some models.
To replace the optical drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or other flat surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See “Removing the computer cover” on page 80.
4. Locate the optical drive. See “Locating major FRUs and CRUs” on page 68.
5. Remove the screw 1 that secures the optical drive, and then slide the optical drive to disconnect the
optical drive from the optical drive cable. Remove the optical drive from the optical drive bay.
Figure 18. Removing the optical drive
6. To install a new optical drive, slide the new optical drive into the optical drive bay to connect the cable to
the optical drive.
Chapter 9
.
Replacing FRUs
83