IOM / Rooftop Smart and Linéa™ Range - Page 45
The intake hood top panel is secured to the unit. The intake
hood sides, filters, and three support brackets are shipped
unassembled in the blower compartment. Assemble hoods
and install as follows :
1. Remove screws securing side flanges of top hood to
unit.
2. Pivot top hood open and secure sides of intake hood
to top of hood using three sheet metal screws on each
side.
3. Align two holes on intake hood side panel with two holes
on bottom (longer) filter bracket. Secure both sides of
bottom filter bracket to hood sides with sheet metal
screws.
INT
INT
INT
INT
INTAKE HOOD
AKE HOOD
AKE HOOD
AKE HOOD
AKE HOOD
4. Secure intake hood sides to unit.
5. Position hood stiffener underneath hood top and align
screw holes with hood top screw holes. Secure with
sheet metal screws.
6. Secure the longer top filter bracket to top of hood. Install
two filters.
7. Slide third filter into bottom filter bracket and hold in
place at the top of the opening with the shorter filter
bracket. Align holes on hood with bracket holes and
secure filter bracket with sheet metal screws.
Figure 59
Seal each end
(field installed)
Hood top
Hood side
Side filter brackets
Shorter top
filter bracket
Longer top
filter bracket
Hood stiffener
Hood top seal
Hood top
Filter
Align vertical holes on bracket with vertical holes on
side of hood
Bottom filter bracket
Top filter bracket
