24
UNIT INSTALLED ON SHOCK ABSORBERS
- The unit is able to work in normal radioelectronics conditions for commercials and residential installations. For
any other conditions please consult.
- If the outside temperature in the area where the heat pump unit is to be installed is low or the cycle functioning
are too long, it may necessary to install a electrical heater, below the likely coils on the drip tray, which avoid the
causing of ice in the coil during defrost cycle.
- If the outdoor unit is going to be installed outside. It may be recommended to install isolation around the panel
of electrical box, to make sure it became hermetic.
- The bedplate is made up of two metal channels, capable of with standing the weight of the units whether hung
from the ceiling or mounted on the floor.
- If the unit is floor mounted, then the profiles should be isolated with shock absorbing material such as anti-vibration
or pads. Keep in mind that fans rotate at approximately 850 rpm.
For the ones with variable pulley belts, see performances tables.
2.- INSTALLATION
Floor supports
(shock absorbers)
2.4.- UNIT LOCATION
