Page 22
A
Run 24VAC control wires through cutout with grommet.
B
Run 24VAC control wires through wire tie.
C
Make 24VAC control wire connections using field provided wire
nuts.
D
Tighten wire tie to security 24V control wiring.
HIGH VOLTAGE FIELD WIRING
LOW VOLTAGE (24V) FIELD WIRING
FACTORY WIRING
CUTOUT WITH
GROMMET
NOTE - FOR PROPER VOLTAGES, SELECT THERMOSTAT WIRE (CONTROL WIRES)
GAUGE PER TABLE ABOVE.
WIRE RUN LENGTH
AWG# INSULATION TYPE
LESS THAN 100' (30 METERS)
18 TEMPERATURE RATING
MORE THAN 100' (30 METERS)
16 35ºC MINIMUM.
WIRE NUTS
BLACK
24V CONTROL WIRES
YELLOW
TIGHTEN WIRE TIE
UNIT LOW VOLTAGE CONNECTIONS
NOTE - DO NOT BUNDLE ANY EXCESS 24VAC CONTROL WIRES INSIDE CONTROL
BOX.
NOTE - WIRE TIE PROVIDES LOW VOLTAGE WIRE STRAIN RELIEF AND TO MAINTAIN
SEPARATION OF FIELD INSTALLED LOW AND HIGH VOLTAGE CIRCUITS.
A
B
C
D
3
NOTE - REFER TO FURNACE, BLOWER COIL AND ACCESSORY INSTRUCTIONS FOR ADDITIONAL WIRING
CONFIGURATIONS WITH OTHER OPTIONAL CONTROLS.
EL16XC1
COND.
UNIT
EL16XC1
COND.
UNIT
EL16XC1
COND.
UNIT
EL16XC1
COND.
UNIT
EL16XC1
COND.
UNIT
EL16XC1
COND.
UNIT
EL16XC1
COND.
UNIT
Figure 13. 24VAC Control Wiring Diagrams (Field Installed)
