15
Coil
Fan motor
Condensate pump
Float switch
1
2
3
4
WARNING
Electric shock hazard can cause injury or death. Before
attempting to perform any service or maintenance on the
unit, turn OFF the electrical power, and check that the fan
has stopped.
Louvres change position to distribute air according to
heating or cooling operation.
iIn
cooling only mode
the louvres are positioned to
distribute air outwards from the discharge, which allow
airflow close to the ceiling.
In
heat pump mode
the louvres are repositioned to blow
air in a downward direction. The air should flow towards
to the floor to prevent layers or stationary hot air forming
in the upper part of the room.
Louvres can be placed on intermediate positions by using
the remote control; as well the louvres may be set to
move continuously, sweep mode. (For more information,
see the remote control manual.)
DIRECCIONAMIENTO DE AIRE
DRIP TRAY
VOLUTE
MAINTENANCE
1
2
Louvre position for correct air flow in heat
pump mode.
Louvre position for correct air flow in cooling
only mode.
When checking or replacing any internal component
of the unit eg coil, fan motor, condensate pump,
float switch, the drip tray and volute must be removed.
• Remove the air intake grille and filter.
• Disconnect the infrared receiver display unit, and
the swing motor wire.
• Disassembly the diffuser panel by removing the
screws that attach it to the unit.
• Detach the two volutes by removing their screws,
and the two electrical panel covers.
• The drip tray can be taken apart by removing its
screws. As shown in the figure.
IMPORTANT:
Do not try to move the louvres, when
they are connected to a motor.
ACCESS TO INTERNAL COMPONENTS
DISASSEMBLING DRIP TRAY
2
3
4
1
1
2
