Lennox Comfair HD, Installation Operating & Maintenance Manual

Page: 15 / 18

2
CLEANING THE AIR
AIR PURIFICATION: AIR CLEAN button
Press the AIR CLEAN button; the message CLEAN is displayed and the negative ion generator is activated and red
lamp illuminates.
CURE AND MAINTENANCE
Cleaning the air filter
Either use a vacuum cleaner to remove the accumulated dust from the filters or wash them with a solution of neutral
soap. In this case let them dry in the shade prior to use.
Installing the air filter
1
Align the filters with the drain duct on the panel and push them as far as they will go.
2 Insert the two filter hooks into the holes in the base unit and press them.
3 Close the cover.
- Before cleaning the unit make sure that it is switched off and disconnected from the power supply.
- There is a high-speed fan inside the unit, which could cause injury to persons.
- Have the unit operate in the fan mode for approx. half a day, if possible when the weather is fine in order to ensure that the
internal parts will be dry.
- When the unit will not be used for a long time, disconnect it from the electricity supply.
- Diesel, petrol, solvents, insecticides and other chemical agents could damage the unit.
- Do not spray hair lacquer or foam or any other inflammable products onto the unit.
- Clean the unit with a cloth soaked in cold or warm water, then wipe dry with another soft, clean, dry cloth.
- Depending on the conditions of use, the internal parts of the unit become dirty after 2 or 3 seasons of use and efficiency could
be jeopardised. For this reason the indicated maintenance is recommended. Contact the authorised after-sales service.
WARNING!
Removing the cover
1
Use both hands to pull the bottom edges of the cover approx. 30° upwards.
2 Push the cover upwards using both hands and lift.
3 Lift the cover up until it can be removed (the grille cannot be removed unless it is raised sufficiently).
Cleaning the front cover
Use a vacuum cleaner to remove the accumulated dust, then clean the grille using a clean, damp cloth. Wipe over
with a clean, dry cloth.
Mounting the front cover
1
Keep the cover horizontal and squeeze the two hooks on the base unit.
2 Insert the hooks at the top of the base unit into the holes in the grille and press on the two bottom sides of the
cover in order to lock it into place.
CLEANING THE AIR FILTER
If dirt collects on the air filter the airflow could be reduced and consequently unit efficiency with a consequent
possible increase in noise. Make sure that the filters are cleaned at the start of a season and during the period of
frequent use. Clean them once a fortnight.
Removing the air filter
1
Remove the front cover.
2 Raise the filters slightly in order to free the two hooks located at the bottom, then pull them downwards and remove.
Two hooks
Filter
slide
INSTALLATION
- OPERATING &
MAINTENANCE
MANU A L
Page 13