4
6. Next, the device should appear under the
Search List
box.
Figure 9. Select Device
7. Select the
Device IP
and perform the following:
a. Change the
Module Static IP
,
Subnet Mask
and
Gateway
to match your local network settings.
b. Select RS485 tab (note, default tab selection is
RS232).
c. Change default
Baud Rate
to
9600
.
d. Change
Work Mode
to
TCP Server
.
e.
S
et
Local Port
number to
10001
.
NOTE:
Since we are using a static IP address here, make
sure no other device on your network is using that
IP address.
8. Press
Base Save
and
Save COM2
to finish.
9. Once saved, you can disconnect the Ethernet cable
from your PC and connect the Ethernet Converter
directly to your router.
