ROUTINE MAINTENANCE
Page 25
DOOR ROPE GASKET
The condition of the rope gasket around the door and
windows should be checked periodically and replaced or
repaired if necessary. A one-inch strip of paper may be
used to perform a test of the integrity of the door seal.
Close the door on the paper in several different locations
and pull. It is normal to feel only a slight amount of fric-
tion. The door gasket does not need to be “tight” in all
areas, since a small amount of leakage is not hazardous
or detrimental to the performance of your stove.
Door Rope Gasket
(check seal at points indicated)
* (Recommended Frequency of 1 year)
Checking Door Seal
Important Note: Paper should be no longer than a
dollar bill.
* (Recommended Frequency of 1 year)
WINDOW WASH
Periodically insert a small piece of cardboard (a busi-
ness card) between the window trim and the window.
Slide the card back & forth a few times to clear any dust
or fibers from the window wash gap. Open the door and
repeat from the other side of the glass.
Window Wash
* (Recommended Frequency of 1 year)
REAR STOVE COMPARTMENT
The rear stove compartment should be cleaned periodi-
cally (a minimum of once a year). DISCONNECT ELEC-
TRICAL CORD PRIOR TO CLEANING STOVE. Any
household dust, pet hair or sawdust should be vac-
uumed or wiped out of the rear compartment of the
stove, room air blower, and Exhaust Blower (paying
special attention to vacuuming out the intakes of both
blowers). The electrical components should be wiped
clean.
MOTOR LUBRICATION
The blowers are permanently lubricated by the
manufacturer.
Do not apply oil to any part of the
blower. Doing so may cause damage.
SMALL AREA PAINT TOUCH-UP (Model T300P only)
Using one small piece of 320 grit sand paper and lightly
sand the blemish so that the edges are “feathered” or
smooth to the touch between the painted and bare sur-
faces. Do not let the sand paper gum up with paint, as
this will cause scratches on the metal surface. If there
are any scratches, use 600 grit sandpaper instead. Mask
off surfaces you do not want painted. Paint lightly over
the bare surface first as this will act as an undercoat.
Then paint over a larger area in smooth even strokes to
blend.
Summary of Contents for Traditions T300P Series
Page 28: ...WIRING DIAGRAM Page 28 ...
Page 33: ...REPLACEMENT PARTS DIAGRAMS Page 33 1 2 3 4 6 7 8 10 11 12 5 9 ...
Page 34: ...REPLACEMENT PARTS DIAGRAMS Page 34 14 15 16 17 20 21 22 24 25 23 27 13 18 ...
Page 36: ...INSTALLATION TIPS Page 36 ...
