LENCO DVT-154, User Manual

Page: 36 / 38

Dolby Digital Setup Dolby Digital Setup
Dynamic Range
- With the dynamic range mode you can adjust the compress
radio . When selected FULL, the peak signal value is smallest.
When selected OFF, the peak signal value is biggest.
Dual Mono
- You can select four different audio outputs, STEREO,
MONO L, MONO R, MIX MONO. The audio out
description of these Selections is shown in the table
below.
MODE LEFT SPEAKER RIGHT SPEAKER
STEREO STEREO-L STEREO-R
L-MONO L-MONO L-MONO
R-MONO R-MONO R-MONO
MIX-MONO L-MONO+R-MONO L-MONO+R-MONO
33
34
Trouble shooting Trouble shooting
Before contacting a service technician, perform the following simple checks. If any problem still persists, unplug the LCD
TV and calling for serving.
No sound and picture
PROBLEM POSSIBLE SOLUTION PROBLEM POSSIBLE SOLUTION
- Check that the main plug has been connected to a wall outlet.
- Check that you have pressed the POWER button on the front of TV set.
- Check the picture contrast and brightness settings.
Normal picture but no
sound
- Check the volume.
- Sound muted? Press the MUTE button.
- Try another channel the problem may be with the broadcast.
- Are the audio cables installed properly.
The remote control does
not work
- Check to see if there any objects between the product and remote control
Causing obstruction.
- Are the batteries installed with correct po to +,- to -).
- Correct remote operating mode set: TV, VCR etc.?
- Install new batteries
Power is suddenly turned
off
- Is the sleep timer set.
- Check the power control settings. Power interrupted.
- No broadcast on station tuned with auto activated.
Picture appears slowly
after switching on
- This is normal, the image is muted during the startup process. Please
contact your service center, if the picture has not appeared after five minutes.
No or poor color or poor
picture
- Adjust the color in the video menu .
- Keep a sufficient distance between the product and the VCR.
- Try another channel, the problem may be with the broadcast.
- Are the VIDEO cables installed properly?
Horizontal/vertical bars
or picture shaking
- Check for local interference such as an electrical appliance or power tool.
Poor reception on some
channels
- Station or cable product experiencing problems. Tune to another station.
- Station signal is weak, reorient antenna to receive weaker station.
- Check for sources of possible interference.
Lines or streaks in pictures - Check the antenna(Change the direction of the antenna).
No output from one of the
speakes
- Adjust balance in the menu audio .