Adjustments
73
10.5.3 Adjusting the tilt angle
Release the guide pins (3) and (4).
Rotate the corresponding rebound har-
row (1) to the required position.
Insert the guide pins (3) as high as pos-
sible directly below the carrier (7) into a
bore in the rear rows of bores.
Insert the guide pins (4) as low as pos-
sible directly above the carrier (7) into a
bore in the rear rows of bores.
Secure the guide pins (4 and 3) by
means of the linch pins (5).
The row of holes (8) should always be approximately perpendicu-
lar to the ground.
10.6 Guide
plates
The angle and height of the guide plates
(1) can be adjusted.
The guide plates (1) refill the groove left by
the rear left hollow disc with earth.
Adjust the guide plates (1) accordingly
using the clamping screws (2).
Make sure that the guide plates (1) are
slightly lower than the harrow tines (3)
on the rebound harrow.
2
4
5
3
7
8
1
3
2
Summary of Contents for Rubin 9 U + K U
Page 2: ......