16
USE INSTRUCTIONS
- Take the appliance out of the box and remove both internal and external packing.
- If the wheels are not installed on the device, remove the motor body (3) of the device. Turn the container (7)
upside down on a stable, clean and resistant surface (ideally on the floor) and install the wheels by pressing
them down into their seats. Once installed, the wheels must not be removed.
- Insert the flexible hose end (10) into the flexible hose joint (8).
- Insert one or two rigid tubes (11) to the other end of the flexible hose, according to the desired length of the
handle.
- Choose the final accessory which you like to use and insert it to the other end of the rigid tubes (11).
Now prepare the filters which are suitable for the use
For sucking dust (dry):
Make sure that the trunk is clean and perfectly dry.
Correctly insert the DRY filter (21), perfectly dry and clean, onto the filter rack (4), by adjusting the rack until it
is completely covered.
Fix the filter-locking elastic (20) to the upper end of the filter (as shown in the picture).
Put the motor body (3) on the containing trunk (7).
Lock the motor body (3) on the containing trunk (7) with both closing hooks (6).
Note: Do NOT suck water or other liquids with the dry filter (21) mounted.
Note: The dry filter (21) must be cleaned after each use.
For sucking water:
Make sure that the trunk is clean and perfectly dry.
Correctly insert the WATER filter (15), perfectly dry and clean, onto the filter rack (4), by adjusting the rack
until it is completely covered.
Put the motor body (3) on the containing trunk (7).
Lock the motor body (3) onto the containing trunk (7) with both closing hooks (6).
Note: The water filter (15) must be cleaned after each use.
Insert the plug into a suitable wall outlet.
Press the switch (2) and put it on “I” position for starting the appliance.
For stopping the appliance, press again the switch (2) and put it on “0” position.
During sucking water, the sucking may be interrupted and the appliance will make an abnormal noise.
Immediately switch the appliance off, remove the plug from the socket, unlock the containing trunk (7) with the
closing hooks (6) and take off the body motor (3). Then empty the content of the trunk.
Blowing function
Remove the cable hook with air outlet (12) by pulling it out.
Insert the terminal of the flexible tube (10) in place of the cable hook with air outlet (12).
The terminal of the flexible tube (10) will snap closed once pulled inside.
WARNING: Never turn the air flow towards people, animals or objects as the outcoming air may be hot.
CLEANING AND MAITENANCE
Clean and wash the filters after each use and replace them if necessary.
Let the filters get completely dry before using them again.
Never use inflammable substances or corrosive agents. Otherwise, they may cause damage to the appliance,
objects and persons.
Do not use detergents to wash the filters.
Do not use hot water to wash the filters.
Check the sucking hoses for possible obstructions caused by objects.
Store the appliance in dry and clean places.
EXPLANATION OF THE SYMBOLS
Note: the product corresponds ONLY to the symbols on the label that you may find either at the back or at the
bottom of the product. The information is purely indicative, please follow scrupulously the instructions found in
the manual and read carefully the paragraphs:
WARNINGS AND GENERAL SAFETY RULES
WARNINGS AND SPECIAL SAFETY RULES
USE INSTRUCTIONS
