LELY Splendimo 550 P, Operating Manual, Page: 24 / 122

Innovators in Agriculture
15-4 Controls and Adjustments Splendimo 550 P
Tongue Swing
Step 1: Ensure controller switch (2) is in the left-hand “N” position.
Step 2: Move tractor hydraulic control for remote valve and hoses (1) in one
direction to swing mower towards the left, or move control in the
opposite direction to swing mower towards the right.
Cutter Bars Fold/Unfold
Step 1: Reduce engine speed to low idle and disengage power takeoff (PTO).
Step 2:
Use tongue swing function as described above to ensure tongue and
mower are centered behind tractor.
Step 3: Ensure cutter bars are raised off of ground.
Step 4: Press and hold controller switch (2) in the right-hand fold position.
Step 5: Move tractor hydraulic control for remote valve & hoses (1) in one
direction to fold cutter bars in for transport, or move control in the
opposite direction to unfold cutter bars to operating position.
Step 6: When fold/unfold is complete, release switch (2) so it returns to the “N”
position.
Proceed as follows before transporting:
• Fully raise cutter bars.
• Adjust pitch control to position (1) as shown on next page.
• Install transport locks. Refer to
page 15-1
.
• Refer to “Preparing for Transport,” page 30-1 .
NOTICE: Never engage PTO while cutter bars are folded
in for transport. Damage to PTO shafts will result.
1
2
!
4.1304.8503.0