LELY 510 CD, Operator'S Manual

Page: 13 / 24

innovators in agriculture
EN-11
4.1
Working width
- The working width can be adjusted by extending the ram of
machine more or less by means of the tractor's double-acting
valve.
The working width can be varied between 3.85 m and 5.10 m.
The working width can be changed while driving by operating the
hydraulic ram. When the tractor is stationary, the ROTONDE rake
must be lifted if the working width is adjusted.
4.2
Swath width
The swath width of the ROTONDE 510 CD rake is adjustable from 1.0
until 1.5 m.
- Adjust the swath boards in the desired swath width.
This should preferably be done after the ROTONDE rake has been
placed in the desired working width by means of the hydraulic
ram. The reason for this is that the swath width will also change
slightly when the working width is adjusted.
4.3
Working height
The working height is adjusted approximatively with the land
wheels underneath the rotors. Fine adjustments are performed with
the top link between the tractor and the machine.
- When ground conditions are normal, the height-adjustable
wheels can be placed in the middle position (fig. 8).
If the ground is soft, the machine must be adjusted 1 or 2 positions
higher in order to compensate for tractor wheelings.
Insert the adjustment pin in the adjustment holes so that the
handle is pointing downwards.
- Adjust the machine in a forward position by means of the top link
so that the bottom of the rake wheel is roughly 5 cm above
ground level at the front (fig. 9).
Depending on the type of crop, the height adjustment of the
wheels and the oblique position may have to be configured
differently.
8
9