LELY 510 CD, Operator'S Manual

Page: 12 / 24

innovators in agriculture
EN-10
4 MACHINE ADJUSTMENTS
Ensure that no-one is near the machine when it is switched
from the transport position to the working position.
Put the machine into the working position as follows:
- Pull the locking hook of the hydraulic ram upwards and push the
ram out. Perform this action while the tractor hydraulics are in the
raised position. The locking hook will now act as a stop in order to
limit the smallest working width (fig. 5).
- Lower the machine to the ground.
- Retrieve the tines from behind the curtain and fold them
outwards (fig. 6).
- Adjust the guide board located in the centre of the machine to the
rear-most position when working in green roughage and to the
front-most position when raking straw. The height adjustment
must be such that the bottom of the guide board tube is
approximately 10 cm above ground level (fig. 7).
A different setting may be required, depending on the type of
crop and ground contours.
5
6
7