Leitronic AG bebetelBluetooth, Manual, Page: 59 / 85

16
9 Special programming
9.1 Factory setting
bébétel
®
can be reset to default values as follows:
1. Set function switch to position OFF.
2. Keep . 3 and . # pressed simultaneously.
3. Set function switch to ON.
4. Release keys
¦
acknowledgement by a beep.
5. Set function switch to OFF.
Note:
ƒ
If there is no beep at step 4, repeat steps 1 to 4.
9.2 Call repetitions
If you want to programme
call repetitions
you can proceed as follows:
1. Set function switch to PROG.
2. Press . * n
3. Enter . 9 . 7 . 1 . 3 . 5 . 3 <n> (n
¦
see table below).
4. Press . * n
5. Enter . 9 . 7 . 1 . 3 . 5 . 3 <n> once again for confirmation.
6. Press . # n
7. If the number is entered correctly there will be one beep at the end of the input. Wrong
re-entering will provoke two beeps. Incorrect number will not be stored so the former
value remains active.
8. Set function switch to OFF.
<n>
Comment
0 bébétel
®
just dials once for each condition (default value)
1..9 bébétel
®
re-dials after the waiting period if a call was not acknowledged by pressing
. 0 . on your telephone. The number of call repetitions is limited to the value of n.
Note:
ƒ
If you use the motion detector we recommend setting call repetitions because it is
possible that the child may cross the monitored section once only.
ƒ
If call recipient is “busy”, the waiting period between two calls is 30 seconds, otherwise 2
minutes.
ƒ
If calls are repeatedly made to an answering machine additional costs can be incurred.
ƒ
If you key a wrong number set function switch to OFF and repeat steps 1 to 7.