Leisure Temp LT1000, Operation Manual

Page: 27 / 45

Page - 24
Recommended Inspection Checklist:
1. Clean Evaporator Coil (As Applicable)
2. Check Contactor Points
3. Check Fan Capacitor Values
4. Check Fan Blade Clearances
5. Clean Heat Pump Cabinet
6. Check Flow / Pressure Switch
7. Apply Rust Inhibitors (As applicable)
8. Verify / Check Air Flow Delta-T
9. Verify / Check Water Flow Delta-T
10. Check Fan Motor Amperage Draw
11. Check and Clear Condensate Drains
12. Check Compressor Capacitor Values
13. Check Compressor Amperage Draw
14. Check Internal Electrical Connections
15. Check Operating Refrigerant Pressures (As Applicable)
16. Check Ambient and Water Temperature Sensors
17. Check Proper Line and Control Voltage to Unit
18. Identify Insect and Rodent Issues with Unit
19. Identify Environmental Conditions of Concern (Run-Off, Sprinklers, etc.)
20. Perform Operating Orientation (As Applicable)
2.8 Winterizing
Failure to properly winterize the heat pump as needed may result in serious equipment damage.
DANGER
Failure to heed the following will result in injury or death.
l
Deactivate power while routing wiring to control board.
l
Follow all National Electric Codes (NEC) and/or State and Local guidelines.
WARNING
Failure to heed the following may result in injury or death.
l
Deactivate all electrical power to heat pump before performing hard freeze procedures.
NOTICE
Failure to heed the following may result in damage to equipment.
l
Failure to winterize heat pump may result in serious equipment damage. Freeze damage is not covered under the
heat pump warranty.
l
While the plumbing connections are in the winterized condition (not fully tightened), it is imperative that water not
run through the heat pump. Loss of water through loose plumbing connections may result in damage to circulation
pump, pool and spa structures, and other equipment.
2
-
M
ai
nt
ena
nc
e