56
18. FAQ, causes and actions UNIROOF 300
Welding result of deficient quality:
• Check drive speed, welding temperature and air volume.
•
with a wire brush (see Maintenance [13.4]).
incorrectly set (see Adjusting welding nozzles [5.1]).
If the set welding temperature has still not been reached after 5 minutes:
• Check supply voltage.
• Reduce air volume.
Device does not move forward in a straight line:
• Align the
track guide roller (16)
so that it is parallel and linear to the
drive/pressure roller (8)
(see Welding sequence [13.2]).
• Adjust the
transport roller (13)
on the movable
transport axle (12)
(see Adjusting the movable transport axle [Patent EP3 028 836 issued] [5.4]).
8
14
13
16
Summary of Contents for UNIROOF 300
