25
Status display 1 / Left
Profile name
Displays the name of the selected currently valid welding profile (such as Basic). If
a profile name contains more than 6 characters, the first
6 characters are shown first, one after the other, followed by the remaining
6 characters. The system presents the first 6 characters afterwards.
Voltage
Display of the supply voltage
Status display 2 / Right
Now press the
Confirm (33). button.
You can now use the
Minus/Plus (32)
buttons to set
the desired setpoint. If you do not make any further
entries, the cursor automatically jumps back to the
Drive icon if Info Mode is not switched on.
During the welding process, the cursor is always on the Drive icon.
You can adjust
the welding speed at any time using the
Minus/Plus (32)
buttons.
If you want to adjust another parameter, first press the
Confirm (33)
button.
Then you can select the desired parameter with the
Minus (32)
button.
Stop Device on Alert
switched on
WLAN
Heating
Undervoltage
GPS data reception
Eco mode
Overvoltage
Data recording
Warning present
The Status display is subdivided into a left-hand (1) and a right-hand area (2).
9.4 Display symbols of the status display (Display 40)
Summary of Contents for UNIROOF 300
