23
If the drive motor does not start automatically after moving in the
welding nozzle (9
), the
drive sensor (6)
adjustment is possibly incorrect
Action
• Set
drive sensor (6)
as follows:
– Turn off
main switch (3)
OFF
– Remove
drive sensor covering (32)
– Lower
hot-air blower (8)
and move as far as the left limit stop
–
Locking lever (11)
must latch in
– Loosen
locking screw (7)
for drive sensor
– Slide
drive sensor (6)
on
tool holder (10)
; IMPORTANT: Sensing distance 0.2 – 0.5 mm
– Tighten
locking screw (7)
for drive sensor
– Mount
drive sensor covering (32)
– Move out
hot-air blower (8)
as far as limit stop and swivel up
– Check function
If the drive motor still does not start automatically, the service centre must be contacted.
Operating preparation
Joining force
• Before putting into operation, check
power supply cord (1)
and connector as well as
extension cable for electrical and mechanical damages.
• Move
lower guide bar (26)
into the required position using
clamping screw,
lower guide bar (31)
and
upper guide bar (27)
using
clamping lever, upper
guide bar (28)
• Clip strain relief of
power supply cord (1)
in
holder (29)
• Check the basic setting of the
welding nozzle (9)
(ex works illustration B and C)
•
Transport setting
– Swivel the
guide roller (18)
upwards
– Release the
transport roller (16)
by raising the
guide bar (27)
– Push the
transport roller (16)
by applying a little pressure to the
shift spring (19)
to the left until it stops (illustration D)
– Position the
hot-air blower (8)
by pulling the
locking lever (11)
and swivel it up
until it locks
Connect tool to rated voltage.
Rated voltage
stated on the device must correspond to line/mains voltage.
Extract hot-air blower in case of
power breakdown
.
Illustration A
•
The welding pressure is transmitted to the
pendulum roller (12)
.
• As necessary, the
additional weights (22)
and the
end weight (23)
can be put on (see illustration A).
Drive sensor adjustment
32
7
11
10
6
3
8
120N
155N
190N
120N
155N
190N
120N
155N
190N
22
12
23
22
120
230
Illustration B
1 mm
Illustration B
9
Illustration D
18 16 19
12