22
Version 1.0, Revision A
Operation
5
No.
Buttons
Description
5
Set button
Touch and hold the button for more than 1 second, and the target
temperature of the present module is displayed.
6
Run/Stop button
•
Touch once - switch on/off the heating to the whole system.
•
Touch and hold - switch on/off the heating to slide dryer(s).
7
LED illumination on/off
Please note that adding the hot water, whose temperature is higher than the target temperature in the
water tray, could delay the use of the instrument.
Please note that accidental drop to ground of the water tray during water exchanging could damage the
water tray and cause possible water leakage or slow the heating.
5.2 Setting the temperature
The displayed temperature corresponds to the current actual value. Touching either of the upwards or
downwards button for about 2 seconds brings the temperature of the instrument to the latest stored
target value. To adjust to the desired temperature, do the following steps.
1. Touch either of the upwards or downwards button till the target module incon occurs.
2. Touch and hold the button till the latest stored target value is displayed.
3. Touch once, and the value is increased/decreased by 0.1°C. Touch and hold the button, and the
value is increased/decreased by 1.0°C after the first integer number is reached.
4. After the desired temperature is reached, release the button.
The displayed value is saved automatically. This stored target value will continue to be displayed
for about 2 seconds, then the current actual temperature display will appear again.
The target value remains saved both when the instrument is switched off (by the run/stop button or the
main switch) and in case of power failure and disconnection from the power supply.
The control panel display will be turned off if all heatings reach the target temperature and no button has
been touched for 5 minutes. Touch any button twice to restore the display.
