Leica GPS1200+, Technical Reference Manual, Page: 1219 / 1442

Survey - General 1219
45.6.5 Initialise on Known Point
Initialise on known
point step-by-step
Step Description Refer to
chapter
1. Refer to "45.6.2 Accessing Initialisation for Real-Time Rover Opera-
tions" to access the initialisation.
2. Does the receiver currently have a fixed solution?
• If
yes , continue with step 3.
• If no , continue with step 4.
3. YES (F6) to start the initialisation. The current ambiguity solution is
discarded.
4. SURVEY Data: Job Name 9.2
This screen is similar to MANAGE Data: Job Name .
Highlight the known point for the initialisation.
5. CONT (F1) starts the initialisation.
)
SURVEY Survey: Job Name
<Point ID:>
The ID of the selected known point is displayed.
<Antenna Ht:> The default antenna height as defined in the active
configuration set is suggested. Changing the antenna height here
does not update the default antenna height as defined in the active
configuration set. The changed antenna height is used until the appli-
cation program is exited.
Enter the correct antenna height.