Leica GPS1200+, Technical Reference Manual, Page: 1214 / 1442

Survey - General 1214
45.6.2 Accessing Initialisation for Real-Time Rover Operations
Requirements • The active configuration set is a real-time rover configuration.
• The configured real-time data format in
CONFIGURE Real-Time Mode is other than <R-
Time Data: RTCM 1,2 v2> and <R-Time Data: RTCM 9,2 v2> .
Access step-by-step The table describes the main access to SURVEY Survey: Job Name .
Access is possible from other screens where individual point measurements are needed, for
example from
COGO Inverse with SURVY (F5) .
Step Description Refer to
chapter
1. Refer to "45.1 Accessing Survey" to access SURVEY Survey Begin .
2. In SURVEY Survey Begin select a job.
3. Select a configuration set with the configured real-time data format
other than
<R-Time Data: RTCM 1,2 v2> and <R-Time Data: RTCM
9,2 v2> .
4. Select an antenna.
5. CONT (F1) to access SURVEY Survey: Job Name .
6. SHIFT INIT (F4) to access SURVEY Initialisation .
7. Highlight the required initialisation method.
)
For Initialise while Static and Initialise on Known Point , the
antenna setup must be static on a pillar, a tripod or on a pole with a
quickstand.