Leica CM1860, Instructions For Use Manual, Page: 25 / 108

25
Leica CM1860/CM1860 UV
Installing the Instrument
4
Warning
Do not slide the instrument by its hood (
→
Fig. 7- 4 ) and observe the transport grip points
(
→
Fig. 7- 3 ) . The castors (
→
Fig. 7- 2 ) must run over the ramp (
→
Fig. 7- 1 ) at the front and rear.
Risk of tipping! The instrument must be transported in an upright postion.
• Carefully roll the instrument backwards over the ramp from the pallet (
→
Fig. 7- 2 ) and slide it on the
castors to the installation location.
Transport to the site
• Check if the location meets the requirements specified in the
(
→
P. 22 – 4.1 Installation site requirements) .
• Transport the instrument to the desired location and observe the following notes:
Warning
• The instrument must be transported in either an upright position or slightly tilted (max. 30 °).
• When tilting the instrument 2 people must counterbalance from the front side as the instrument can
tip over and cause severe injury, as well as severe damage to the instrument and the surrounding
area!
• When transporting the instrument on the castors ( → Fig. 8- 2 ) , grip the instrument only at the marked
housing locations (
→
Fig. 8- 3 ) .
• To ensure a secure upright position at its intended location, the instrument must be adjusted. To do so,
unscrew both adjusting feet (
→
Fig. 8- 1 ) using the provided open-end wrench (size 13) (
→
Fig. 8- 4 ) .
• When subsequently transporting the instrument any further on castors, screw them back in all the way.
1
1
4
2
2
3
3
2
Fig. 8