222
44
11
33
19824_002
55
1.
Open the handle by removing the filter cover.
2.
To remove the filter cartridge:
a
)
Grab the bottom flap with your thumb and index finger.
b
)
Gently push the filter cartridge toward the impeller and raise up
the bottom part of it.
c
)
Slide the filter cartridge back few millimetres, then remove it.
3.
Close the impeller suction side with the provided maintenance plug
immediately after the removal of the filter cartridge.
☞
The following steps
to
shall not be done in the same room as
the mounting/dismounting takes place.
4.
Clean the filter cartridge with fresh clean compressed air, for
example with a compressed gas duster. Clean it from the inside of
the filter cartridge to the out and not the vice versa.
5.
Clean the air inlet with fresh clean compressed air, for example with
a compressed gas duster. Clean it from the inside out and not the
vice versa.
6.
The air outlet rarely has to be cleaned. If needed, clean it gently
with a small brush. Remove dust, laying down in the aluminium ribs.
☞
If some particles of dust are clearly stuck inside the mesh
fibers, do not try to remove them. It may force the
particles to move further in and damage the mesh.
☞
Do not use compressed air to clean the air outlet.
Care and Transport
35
