15
LEHLE GmbH · Germany · www.lehle.com · [email protected]
3. Calibration of the relay switch output
The relay of the 10K socket is an elec-
tronic switch, which can perform a mo-
mentary or latching switch signal, e.g. to
switch a channel at an amp or control a
switch-input of a digital device.
You can set the position where the relay
shall be triggered.
In the calibration process menu (1.) the
10K soft touch button needs to pressed.
The blue switch LED starts flashing.
Move the rocker within 3 seconds (say
“Lehle switcher” three times) to the
position you want the relay to be trig-
gered.
The maximum position will be learned
and stored inside.
The calibration process is finished when
the blue switch LED stops flashing and
goes off.
The LEHLE DUAL EXPRESSION reboots
again.
A classic usage would be to move the
rocker to the maximum toe position and
then give it a little push with your toes.
This way you can simulate the behaviour
of a typical Wah pedal switch.
It even works in reverse: Stay within the
3 seconds in the most minimal position.
This way the relay would be triggered if
you are moving into the heel position.
Even in the mid of the pedal range the
relay can be triggered.
!
On page 25 you will find a user flow
map, where all these procedures are
shown.
