301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 6 of 8
INSTRUCTION/INSTALLATION SHEET
lyriQ™ Studio High Performance
Keypad
IS-0425 REV. A
©Copyright 2009 by On-Q/Legrand All Rights Reserved.
button turns blue).
In this mode, all functions performed on the local keypad such as Volume Up/Down, Mute/Un-Mute, Source
selection, or Power On/Off are relayed to and performed on all active keypads in the system.
NOTE: The Whole-House mode will be exited when the user fails to press a key within 10 seconds or by
pressing the WHOLE HOUSE button again.
H. DIMMING set-up:
Press and Volume- at the same time to enter mode. Backlights will flash. Press + or – to adjust level
of light.
I. POWER UP SELF TEST (see
Figure 5
):
Keypad only – When power is applied to the Studio Keypad, the following start up test will occur:
1) The Keypad white backlight LEDs will illuminate to full intensity.
2) The MUTE button backlight will transition to red and back to white.
3) The WHOLE HOUSE button backlight will transition to blue and back to white.
4) The volume indicator LEDs and then source indicator LEDs will illuminate left to right and then back to the left.
5) The Keypad white backlight LEDs will dim to off and the Standby button will be backlit red.
6) When done, the Keypad powers down,
NOTE: The first 5 power up self tests will take about 15 seconds, and about 2 seconds after that. Hitting any
button during the test will interrupt the test and the Keypad will operate as normal.
5. Important Safety Precautions:
Read the instructions that are included with all associated lyriQ™ Audio products before installing any single component. If
you are unsure of any of the installation procedures contact On-Q/Legrand Technical Support @ 1-800-321-2343 option 1 or
contact an On-Q/Legrand installer.
•
Do not attempt to service, move or change any component of the lyriQ™ Audio system unless you are qualified to do so.
•
This system should be installed by a qualified installer and must conform to all local building and electrical codes.
•
Do not apply power to the lyriQ™ Audio System until all components are installed and wiring is properly terminated.
•
Do not attempt to terminate, change or un-install any wiring without first turning off power to the lyriQ™ Audio System
located in the Enclosure. Unplug the power to the lyriQ™ Audio System from the power outlet before proceeding with
wiring terminations or changes.
•
Install all system components away from heat sources such as HVAC ducts/registers, stoves or any other heat source.
•
Do not expose any component that was designed for indoor use to moisture. Doing so can create electrical hazards or
render the component unusable. Exposure to moisture will also void the warranty on the system.
•
Do not use vacuum cleaners, liquid or aerosol cleaners to clean system cover plates. A damp cloth may be used.
6. Installer Set Up Mode (see Page 7 and 8)
