INSTRUCTION / INSTALLATION SHEET
Selective Call Intercom Door Unit
IS-0387 Rev. B
301Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2011 by Legrand All Rights Reserved.
Page 2 of 3
NOTE: Make sure that the included weather proofing gasket is placed as shown in Figure 3.
1. As shown in
Figure 3
, the first step to installing the
Selective Call Door Unit is to place the included rear
gasket against the gang or back box, and secure the
gasket in place with the included mounting bracket.
NOTE: Insure that the mounting bracket is installed with
the center tab pointed up, as the Door Unit will be
“hung” from this tab in a later step.
NOTE: There are slotted holes in the mounting bracket
to allow for leveling of the Door Unit in case the gang or
back box was installed off level.
2. Use the four provided screws to attach the mounting
bracket to the gang or back box.
3. Pull the Cat 5 cable from the enclosure through the mounting bracket and terminate the cable with an
RJ45 plug and insert the plug into the RJ45 jack on the rear of the Door Unit (see
Figure 4
). Follow
the T568A standards described in
Figure 2
.
NOTE: There is a four position terminal block on the rear
of the Door Unit that can be utilized for two different
purposes (see
Figure 5
). The CHIME output is a normally
open dry contact closure used to ring a customers 3
rd
party door chime when the Door Unit button is pressed.
The SENSOR input is reserved for a future application.
4. Hang the Door Unit from the top tab on the mounting bracket and
use the provided 1/16” allen wrench to tighten the two set screws
at the bottom of the Door Unit.
5. Terminate the other end of the Cat 5 cable, at the Selective Call
Intercom Module, with an RJ45 plug using the T568A wiring
standard.
6. Insert the RJ45 plug into any of
the eight Room, Patio, or Door
Unit jacks on the Intercom Module
(labeled 1-8).
7. After all Units and Modules are
connected, apply power to the
Selective Call Intercom Module
and verify system functionality. All
Selective Call Room, Door and
Patio Units will be discovered and
shown on each Room Unit LCD.
Figure 3
rear
gasket
center tab
mounting
bracket
set screws
RJ45
jack
Figure 4
Figure 5
